1. PRODUCT AND COMPANY IDENTIFICATION
Product Name: Roof Cleaner Product Use Description: Waterborne, high-performance cleaner for hard-to-clean, single-ply roof surfaces, such as weathered black EPDM Manufacturer: NanoTech Materials, Inc. 21401 Park Row Drive #360 Katy, TX 77449
Email: [email protected]
Telephone: 1-(888) 296-6266
2. HAZARDS IDENTIFICATION
GHS Label Elements Hazard Pictograms: Signal Word: Warning Hazard Statements: Causes skin irritation. Causes serious eye irritation. Hazard Classification Skin Corrosion/Irritation: Category 2 Serious Eye Damage/Eye Irritation: Category 2A Precautionary Statements Prevention: Wear safety glasses with side shields (or goggles). Wear protective gloves. Wash hands thoroughly after handling. Response: IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: Get medical advice/ attention. IF ON SKIN: Wash with plenty of soap and water. If skin irritation occurs: Get medical advice/attention. Wash contaminated clothing before reuse. Storage: Store away from incompatible materials. Keep out of reach of children. Disposal: Dispose of waste and residues in accordance with local authority requirements. Hazards Not Classified: None known.
3. COMPOSITION/INFORMATION ON INGREDIENTS
Mixture of Chemical Name CAS Number % by Weight
D-Glucopyranose, oligomeric,
C10-16-alkyl glycosides 110615-47-9 1–5%
D-Glucopyranose, oligomeric,
C8-10-alkyl glycosides 68515-73-1 2–10%
Xylenesulphonate (SXS) 1300-72-7 2–10%
Tetrasodium
ethylenediaminetetraacetate 64-02-8 1–5%
Alcohols, C9-11, ethoxylated 68439-46-3 5–25%
N,N-dimethyl 9-decenamide 1356964-77-6 1–10%
Other materials below reportable
quantities — 50–70%
4. FIRST-AID MEASURES
Skin: Wash skin thoroughly with soap and water. If skin irritation or rash occurs: Get
medical attention. Launder contaminated clothing before reuse.
Eyes: Any material that contacts the eye should be washed out immediately with water. If
easy to do, remove contact lenses. Inhalation: Remove exposed person to fresh air, if adverse effects are observed. Ingestion: Treat symptomatically. Get medical attention. Most important symptoms/effects, acute and delayed: Symptoms: See section 11 Indication of immediate medical attention and special treatment needed:Treatment: Treat symptomatically.
5. FIRE-FIGHTING MEASURES
General Fire Hazards: No unusual fire or explosion hazards noted. Suitable (and unsuitable) extinguishing Suitable extinguishing media: CO2, dry chemical, foam, water spray, water fog Unsuitable extinguishing media: None known. Hazardous Combustion Products: Not determined. Special protective equipment and precautions for firefighters Special fire-fighting procedures: No data available Special protective equipment for fire fighters: Wear full protective fire gear including self-containing breathing apparatus operated in the positive pressure mode with full face piece, coat, pants, gloves and boots.
6. ACCIDENTAL RELEASE MEASURES
Personal precautions, protective equipment and emergency procedures:Do not touch damaged containers or spilled material unless wearing appropriate protective clothing. Keep unauthorized personnel away. See Section 8 of the SDS for Personal Protective Equipment. Ventilate area if spilled in confined space or other poorly ventilated areas. Personal Protective Equipment must be worn. See Personal Protection Section for PPE recommendations. Methods and material for containment and cleaning up: Dike far ahead of larger spill for later recovery and disposal. Pick up free liquid for recycle and/or disposal. Residual liquid can be absorbed or inert material. Wash area with soap and water. Spilled liquid and dried film are slippery. Use care to avoid falls. Environmental Precautions: Avoid release to the environment. Do not contaminate water sources or sewer. Environmental manager must be informed of all major spillages. Prevent further leakage or spillage if safe to do so
7. HANDLING AND STORAGE
Precautions for Safe Handling: Avoid breathing dust/fume/gas/mist/vapors/spray. Avoid contact with eyes, skin and clothing. Observe good industrial hygiene practices. Provide adequate ventilation. Wear appropriate Personal Protective Equipment. Wear appropriate Personal Protective Equipment. Wash hands thoroughly after handling. Contaminated work clothing should not be allowed out of the workplace. Launder contaminated clothing before reuse. Avoid contact with eyes and prolonged or repeated contact with skin. Avoid breathing mist or vapors. When using, do not eat, drink or smoke. Stir well before use. Keep containers closed when not in use. Minimize contact with air to reduce contamination with mold, fungus, or other organisms which could cause decomposition or spoilage. Wash thoroughly after handling. Conditions for Safe Storage: Store in a cool dry place. Keep container(s) closed. Maximum Storage Temperature: Not determined. Conditions for Safe Storage, Including Any Incompatibilities: Store away from incompatible materials. See section 10 for incompatible materials. Keep from freezing. Do not store in open, unlabeled or mislabeled containers.
8. EXPOSURE CONTROLS / PERSONAL PROTECTION
Control Parameters Occupational Exposure Limits: None of the components have assigned exposure limits. Appropriate Engineering Controls: Use material in well ventilated area only. Adequate ventilation should be provided so that exposure limits are not exceeded. Mechanical ventilation or local exhaust ventilation may be required. Individual protection measures, such as Personal Protective Equipment Ventilation: Use local exhaust ventilation or other engineering controls to minimize exposures. General Information: Use Personal Protective Equipment as required. Eye/Face Protection: If contact is likely, safety glasses with side shields are recommended. Skin and Hand Protection: Use good industrial hygiene practices to avoid skin contact. If contact with the material may occur wear chemically protective gloves. Suitable gloves can be recommended by the glove supplier. Other: Wear gloves, coveralls, apron, boots as necessary to minimize contact. Do not wear rings, watches or similar apparel that could entrap the material. Respiratory Protection: Consult with an industrial hygienist to determine the appropriate respiratory protection for your specific use of this material. A respiratory protection program compliant with all applicable regulations must be followed whenever workplace conditions require the use of a respirator. Under normal use conditions, a respirator is not usually required. Use appropriate respiratory protection if exposure to dust particles, mist or vapors is likely. Use self-contained breathing apparatus for entry into confined space, for other poorly ventilated areas and for large spill clean-up sites. Hygiene Measures: Observe good industrial hygiene practices. Avoid contact with skin. Contaminated work clothing should not be allowed out of the workplace.
9. PHYSICAL AND CHEMICAL PROPERTIES
Appearance / Physical State: Liquid
Form: Liquid
| Color: | Light amber |
| Odor: | Slightly sweet |
Odor threshold: No data available
pH: 9.7 (concentrate) / 9.2 (1:10 dilution)
Melting / Freezing Point: 32°F (0°C) Boiling point: 212°F (100°C) Flash point: None to boiling — not flammable Evaporation rate: N/A Flammability (solid, gas): N/A Upper/lower limit on flammability or explosive limits Flammability limit – upper (%): N/A Flammability limit – lower (%): N/A Vapor pressure: N/A Vapor density: N/A Relative Density / Specific Gravity: 1.09 Solubility in Water: Soluble Partition coefficient (n-octanol/water):N/A Auto-ignition temperature: N/A Decomposition temperature: N/A Viscosity: Water-thin / low viscosity Other information VOC (Weight %): 0 Percent solid: Approximately 10 to 20 wt% Percent volatile: Approximately 80 to 90 wt%
10. STABILITY AND REACTIVITY
Reactivity: No data available Chemical Stability: Material is stable under normal conditions. Possibility of Hazardous Reactions: Will not occur. Conditions to Avoid: Do not freeze. Incompatible Materials: No data available. Hazardous Decompositions Products: Thermal decomposition or combustion may generate smoke, carbon monoxide, carbon dioxide, nitrogen oxides and other products of incomplete combustion Irritating and toxic substances may be emitted upon combustion, burning or decomposition of dry solids.
11. TOXICOLOGICAL INFORMATION
Information on likely routes of exposure:
Eyes Contact: Moderate irritation, including redness, swelling, pain, tearing and hazy vision. May cause irritation, discomfort, reddening and tearing. Skin Contact: Prolonged contact may cause irritation and/or redness. Inhalation: Inhalation of high concentrations may cause headache, nausea, and dizziness. Overexposure could cause coughing, sneezing, and labored breathing. Ingestion: May cause irritation of the respiratory tract and CNS effects such as dizziness, headaches, and nausea. Information on toxicological effects Acute Toxicity Oral: Product: No data available. Dermal: Product: No data available. Inhalation: Product: No data available. Skin Corrosion/Irritation: Product: No data available. Serious eye damage/eye irritation: Product: No data available. Respiratory sensitization: No data available. Skin sensitization: No data available. Specific target organ toxicity – Single exposure: No data available. Aspiration Hazard: No data available. Other Effects: No data available. Chronic Effects – Carcinogenicity IARC monographs on the evaluation of carcinogenic risks to humans: No carcinogenic components identified U.S. National Toxicology Program (NTP) report on carcinogens: No carcinogenic components identified U.S. OSHA specifically regulated substances (29 CFR 1910.1001- 1050): No carcinogenic components identified Germ cell mutagenicity: No data available Reproductive toxicity: No data available Specific target organ toxicity repeated exposure: No data available.
12. ECOLOGICAL INFORMATION
ECOLOGY – GENERAL: Ecological evaluation of this material has not been performed; however, do not allow the product to be released to the environment without government approval/permits. Discharge into the environment must be avoided. Ecotoxicity
Fish: No data available
Aquatic invertebrates: No data available Toxicity to aquatic plants: No data available Toxicity to soil dwelling organisms: No data available Sediment toxicity: No data available Toxicity to microoganisms: No data available Persistence and degradability biodegradation: Based on the biodegradability data of the components, this material is expected to be biodegradable. Bioaccumulative potential bioconcentration factor (BCF): This material does not contain chemicals that have known bioaccumulative potential. Mobility: No data available Other adverse effects: No other adverse environmental effects (e.g., ozone depletion, photochemical ozone creation, endocrine disruption, global warming potential) are expected.
13. DISPOSAL CONSIDERATIONS
Waste Disposal Methods: Treatment, storage, transportation and disposal must be in with all applicable local, state and federal regulations. Dispose of packaging or containers in accordance with local, regional, national and international regulations.
14. TRANSPORT INFORMATION
DOT: Not regulated
Shipping descriptions may vary based on mode of transport, quantities, temperature of the material, package size, and /or origin and destination. It is the responsibility of the transporting organization to follow all applicable laws, regulations and rules relating to the transportation of the material. Review classification requirements before shipping materials at elevated temperatures.
15. REGULATORY INFORMATION
U.S. Federal Regulations
- CERCLA - SARA Hazard Category
This product has been reviewed according to the EPA “Hazard Categories” promulgated under Sections 311 and 312 of the Superfund Amendment and Reauthorization Act of 1986 (SARA Title III) and is considered, under applicable definitions, to meet the following categories:
- SARA SECTION 313
This product contains the following substances subject to the reporting requirements of Section 313 of Title III of the Superfund Amendment and Reauthorization Act of 1986 and 40 CFR part 372:
- TOXIC SUBSTANCES CONTROL ACT
This product contains the following chemical substances subject to the reporting requirements of TSCA 12(B) if exported from the United States: No TSCA components exist in this product. U.S. State Regulations
- NEW JERSEY RIGHT-TO-KNOW
Not regulated.
- PENNSYLVANIA RIGHT-TO-KNOW
Not regulated.
- MASSACHUSETTS RIGHT-TO-KNOW
Not regulated.
- RHODE ISLAND RIGHT-TO-KNOW
Not regulated.
- CALIFORNIA PROPOSITION 65 CARCINOGENS
This material is not known to contain any chemicals currently listed as carcinogens.
- CALIFORNIA PROPOSITION 65 REPRODUCTIVE TOXINS
This material is not known to contain any chemicals currently listed as reproductive toxins.
- CLEAN AIR ACT (CAA) SECTION 112 HAPS:
Not regulated.
- CLEAN AIR ACT (CAA) SECTION 112(R):
Not regulated. International Regulations
- CANADIAN WHMIS: This SDS has been prepared in compliance with Controlled Product Regulations.
- Chemical Inventories Australia inventory (AICS):
Australia (AICS): Not Determined | Canada (DSL): Not Determined | Japan (ENCS): Not Determined | China (IECSC): Not Determined | Korea (KECI): Not Determined | New Zealand (NZIoC): Not Determined | Philippines (PICCS): Not Determined | United States (TSCA 8b): All components listed or exempted.
16. OTHER INFORMATION, INCLUDING DATE OF PREPARATION OR LAST REVISION
HMIS Hazard ID Health: 1 – Slight Flammability: 0 – Minimal Physical Hazards: 0 – Minimal Hazard rating: 0 – Minimal 1 – Slight 2 – Moderate 3 – Serious 4 – Severe *Chronic health effect NFPA Hazard ID Flammability Health Reactivity Special Hazard Hazard rating: 0 – Minimal 1 – Slight 2 – Moderate 3 – Serious 4 – Severe *Chronic health effect Issue Date: 10/24/2024 Source of Information: Internal company data, suppliers and other publicly available resources. Further Information: Contact supplier (see Section 1) Disclaimer: As the conditions or methods of use are beyond our control, we do not assume any responsibility and expressly disclaim any liability for any use of this product. Information contained herein is believed to be true and accurate but all statements or suggestions are made without warranty, expressed or implied, regarding accuracy of the information, the hazards connected with the use of the material or the results to be obtained from the use thereof. Compliance with all applicable federal, state, and local regulations remains the responsibility of the user.